Lishi 2in1 Decoder for Benz,Maybach,Lorinser,Carlson Cylinder Lock
(HU64v.3)
Features & Functions
*Use this tool can locate accurate technical open Benz,Maybach,Lorinser,Carlson car external milling 2 track door lock,ignition lock and trunk lock,can be read out all the teeth number,can be cut model key open - according to the model match the key;
*Operate easy,convenient,all stainless steel refined;
*Durable,provide wholesales;
Lock Direction TIPS:
when the main operater cabin on the left side use counterclockwise opening, clockwise to open when the right;
Lock Introduction:
The lock including 10 shrapnel places and have 5 teeth depth ,NO.1 the most shallow,NO.5 is the deepest,
Teeth is available to be read after cylinder unlocked
Special Skill TIPS:
because the trunk lock hole is handstand status,if feel the pose is difficult,we can via read out the door lock shrapnel make key to open,
If when open the door,to open in the direction of the open shrapnel is easier to fall down repeatedly,to open in the direction of the lock will more easier,can reverse open,
Read number and according to the number open or make key to open,(left rudder car some new locks in turn to the right after a small angle,test every shrapnel has a tooth depth bounce,number is readable)
This lock key have 10 tooth bit,5 tooth depth.
Explain to the rear of the open method below:
Technique: push rod right strength,clockwise strength,test every shrapnel,crowbar to pry depends on the left hand while putting hard situation,if the push rod strenuous a large,pry motionless,must as lever,two hand to cooperate to return,
In the above of 5 motionless is 4 or 3,under 5 motionless is 2 or 1,move in the 5 is 5,
Read tooth after open,press the moving ones to the end,pressed to the fixed is tooth number,benz car HU64,10 tooth bit,total have 9 tooth,also some of have 10 tooth,trunk and ignition have 10 tooth,
According to the read out tooth number to open in the direction of front of the car,open in the direction of front technique is more practical,to open in the rear of the car,hand and push rod need a little light will more easier to open,when open in the direction of the front car must control every lock plate,click every lock plate need to control the strength of push rod,otherwise it will fall down after finished click,
Push the known # 1 in the place first,when move above must be put below inside,move the below must be put the above inside,click in place repeatedly,the lock can be open,
Some of door lock after turn 90° towards left,don't move the tool stop in this place,at this time to pull the door handle,when heard a mechanical noise,put the door handle return,pull the door handle again can be cancel the door lock institutions;
LISHI Genuine
Our Company is agent of Lishi 2in1 tool, offering after-sale service on Lishi, no more worry the guaranty!
|
